Mikado LOGO 200 Super Bind & Fly COMBO
- BNF-RTF Micro Helicopter for VBar Control radio (bind and fly, ready to fly)
- Exceptional flight performance, comparable to larger 600-700 class helis
- Equally suitable for sports flying, aerobatics and 3D flying
- Wide range of head speeds, from 2,500-7000+ 1/min possible
- Lipo 3S-650 mAh battery for flight times from 4-9 min. (included)
- Dual Motor System, direct drive for main and tail rotor
- Dual ESC with metal case
- VBar NEO mini 6.4 Flybarless System with 'Anti Gravity'
- VBar NEO already set up, no setup on your own required, just bind and fly
- VBar NEO Governor with RPM telemetry
- Micro digital servos with metal gears for the swashplate
- Carbon frame and landing gear
- Aluminum rotor head and swashplate
- VTX main rotor blades
- Glass Fiber Airbrush canopy
This LOGO 200 does not support other radio systems than VBar Control, without further adjustments.
At your own discretion, you can use VBar Control to select a digital third party protocol as an input, and make the necessary channel adjustments.
You then obviously also need a suitable separate third party receiver.
Adjustments to the flight parameters can only be made with VBar Control. VBar NEO mini can not be set up via computer software.
If set up properly, you can then fly the model with VBar's motor switch logic, three parameter banks, and use Rescue and/or Beginner mode (if installed).
Specifications:
- Rotor diameter: 400 mm
- Rotor blades: VTX 173 mm
- RTF weight: approx. 310 g
- recommended batterie: Lipo 3S-650 mAh (included)
- Main gear ratio: 1
- Tail gear ratio: 1
- Main Gear size: ./.
- Length: 420 mm
- Hight: 135 mm
- Width: 74 mm
Content
Kit LOGO 200 Super Combo ARF
Motors: OMPHOBBY
ESC: OMPHOBBY
VBar electronic: VBar NEO mini VLink 6.4
Servos: 3 x digital micro servo w/ metal gears, OMPHOBBY
Blades: VTX 173 mm
Tail Blades: 71 mm
Canopy Airbrush canopy
